Lightolier A0100 Dépliant

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA  02720

1. Twist DIFFUSER counterclockwise and remove. 

2. Partially thread supplied MOUNTING SCREWS into OUTLET BOX.

3. While supporting FIXTURE HOUSING, make electrical 

connections: black fixture lead or fixture lead without tracer
marks to hot (black) supply lead; white fixture lead or fixture lead
with tracer to neutral (white) supply lead. Green fixture wire is a
ground and must be connected to grounding terminal or ground
lead inside OUTLET BOX. Use WIRE NUTS (local hardware item).
Push connections back into OUTLET BOX.

4. Position FIXTURE HOUSING over MOUNTING SCREWS and allow

heads of MOUNTING SCREWS to come through KEYHOLE SLOTS
in FIXTURE HOUSING. Turn FIXTURE HOUSING until SCREWS
fully engage in narrow portion of KEYHOLE SLOTS and secure in
place by tightening MOUNTING SCREWS.

5. Install recommended lamp(s).

6. Re-install DIFFUSER to FIXTURE HOUSING. Align the three 

bracket tabs with details in DIFFUSER, then rotate clockwise.

OUTLET BOX

GROUND WIRE

WIRE NUT

FIXTURE HOUSING

MOUNTING SCREWS

REFLECTOR ASSEMBLY

REFLECTOR SCREW

SHADE (IF PROVIDED)

DIFFUSER

RETAINING
CLIP

DIFFUSER
MOUNTING
TAB

PROTRUSION

DIFFUSER
NOTCH

KEYHOLE SLOT