Lightolier 1004SIC Dépliant

a Genlyte company 

www.lightolier.com

631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2006 Genlyte Group LLC • I0806

Lytecaster

®

 Recessed Downlighting 

Page 1 of 1 

5" Aperture 

0

®

 Shallow Incandescent Convertible IC/Non-IC Frame-in Kit

1.  Housing:  .032” (#20 ga.) Aluminum. UL listed convertible IC/NON-IC.  2" 

vertical adjustment in ceiling. Can be removed for access to junction box and 
ceiling plenum. 5 1/2" tall for use in 2" X 6" joist construction and shallow 
plenum applications. AirSeal

®

  housing minimizes air leakage to less than 2 

CFM at 1.57 PSF (or 75pa), which complies with Model Energy Code (Section 
602.3.3) and Washington State Energy Code (Section 502.4) and reduces heat 
loss and condensation in ceiling.

2.  Mounting Frame:  .048" (#18 ga.) galvanized steel. Locks into position along 

length of mounting bars with locking spring and bendable slot.  (3) slots 90° 
apart simplify alignment.

3.   Junction Box:  2" X 4" X 3 1/2" (22 cu. in.) .032" (#22 ga.) galvanized steel. 

UL listed for maximum of 8 (#12 ga.) 1104SIC/N and 6 (#12 ga.) 1004SIC/N 
90°C through branch circuit conductors. Integral cable clamps permit 
attachment of non-metallic (#12 or #14 ga.) Romex

®

 cable without tools or 

additional connectors.

4.  Mounting Bars:  .059" (#16 ga.) galvanized steel. Bars pivot for easy 

attachment and wire-in below ceiling line. Bars extend to accommodate 
16" to 24" O.C. joist spacing. Bars can accommodate 9" O.C. joist spacing 
after a slight field modification (See Instruction Sheet). 1004SIC features 
integral self-tapping phillips screws for secure attachment to wood or metal 
construction. The 1004SICN features integral nails for secure attachment to 
wood. Both attach to T-bar ceilings without the need of accessories.

5.  Socket Housing:  Impact extruded aluminum or galvanized steel.  Attached 

trim retaining spring secures trim to any height on housing wall.

6.   Socket:  Porcelain medium base; nickel plated screw shell. Pre-wired with 

#18 ga. SF1 (300 Volt 200° C) leads to junction box.

7.    Thermal Protector:  Meets NEC and UL requirements. Located inside 

housing.

NOTE:  Use only if factory installed tape or knockouts are removed from vertical  

 

adjustment slots in housing wall.

UL (Type IC/NON-IC Convertible, Suitable for Damp Locations)
Complies with Air Leakage Requirements stated in the Model Energy Code and 
the Washington State Energy Code.

 

 

 

            Open Downlight 

 

 

 

Cone 

Satin Cone 

Baffles 

Basic White 

Wall Washer 

Enclosed Diffuser 

AirSeal

®

 is a registered trademark of Lightolier.

Romex

®

 is a registered trademark of General Cable Industries Inc.

*for Non-IC applications only