Cooper Lighting MD6CPxT6 Manuale Utente
704530 Rev. A
- 3 - Customer First Center · 1121 Highway 74 South · Peachtree City, GA 30269
Portfolio
®
Distribution Selection & Trim Installation
Step 1. Install the proper lamp type and wattage into the socket. Make sure the new lamp does not have any
fingerprints, dust, lint, etc.
NOTE:
The lamp-socket assembly is installed onto the trim in one of three possible positions. These are labeled
Narrow, Medium and Wide. The selected position determines the light distribution from the fixture.
Narrow, Medium and Wide. The selected position determines the light distribution from the fixture.
Step 2. As shown in figure at right, the trim assembly includes
six plastic lockout inserts. Remove and discard the
two lockouts from the desired distribution positions.
For example, if a Medium distribution is desired,
remove the two lockouts closest to the “Medium”
labels.
two lockouts from the desired distribution positions.
For example, if a Medium distribution is desired,
remove the two lockouts closest to the “Medium”
labels.
NOTE:
It is intended that the remaining plastic lockouts remain
in place. This will help avoid any inadvertent
distribution changes during re-lamping in the future.
in place. This will help avoid any inadvertent
distribution changes during re-lamping in the future.
Step 3. Secure the lamp-socket assembly in the desired
distribution position with the two thumbscrews.
Step 4. Install the trim into the housing. The trim’s torsion
springs pass through slots in torsion spring receivers
inside the housing.
inside the housing.