Chauvet 6000X Manuale Utente

 

 

 

 

 

Your product is equipped with an internal input-voltage select switch.  
 

 

Remove the right base 
cover panel as 
illustrated here to gain 
access to the switch 
shown below. 

Input Voltage Switch 

2 

3 

3,4,5 

•  To determine the power requirements for 

a particular fixture, see the label affixed to 
the back plate of the fixture or refer to the 
fixture’s specifications chart.  

•  A fixture’s listed current rating is its 

average current draw under normal 
conditions.  

•  All fixtures must be powered directly off a 

switched circuit and cannot be run off a rheostat (variable 
resistor) or dimmer circuit, even if the rheostat or dimmer 
channel is used solely for a 0% to 100% switch.  

•  Before applying power to a fixture, check that the 

source voltage matches the fixture’s 
requirement.  

•  All fixtures must be connected to circuits 

with a suitable Earth Ground.  

 

1.  Make sure the fixture is not connected to power, if 

so disconnect. 

2.  Remove the right base access cover panel as 

illustrated on the right.  

3.  Locate the power selection switches and dial.  

4.  Rotate the voltage dial to the setting that most closely matches the local AC voltage. If your 

voltage falls halfway between two settings, select the higher voltage on the dial.  

5.  Move the frequency switch to the setting that matches the local AC frequency; 50 or 60 Hz.  

6.  Replace access cover.  

Live L 

Neutral N 

Earth EG 

(Ground) 

LEG-6000 User Manual 

 

7 

Revision: 2007-03-06/09:06