Chauvet TFX- 125BL Manuale Utente
TFX-125BL User Manual
5
Revision: 2004-11-02/11:32
Remove both thumbscrews
Figure 2 – TFX-125 Lamp Installation
Slide switch up or down depending
on your line voltage.
on your line voltage.
S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. A bulb is included with your
product.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L A M P I N S T A L L A T I O N
1)
Remove both thumbscrews located on the front of the
fixture and open the lamp cover.
fixture and open the lamp cover.
2)
If replacing the lamp, remove old lamp first by unscrewing it
from its base.
from its base.
3)
Hold the new lamp with a lint-free cloth or napkin and screw
lamp into the socket providing minimal torque to secure
lamp in place.
lamp into the socket providing minimal torque to secure
lamp in place.
4)
Close lamp cover, align the screw holes and fasten the
thumbscrews back onto the cover.
thumbscrews back onto the cover.
Power
Your product is equipped with switch-selectable AC power
setting and frequency.
Warning!
Verify that the power select switch on your unit
matches the line voltage applied. All fixtures must
be connected to circuits with a suitable Earth
Ground.
matches the line voltage applied. All fixtures must
be connected to circuits with a suitable Earth
Ground.
• To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture’s specifications chart.
• A fixture’s listed current rating is its average current draw under normal conditions.
• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture’s
requirement.
• All fixtures must be connected to circuits with a suitable Earth Ground.
• When in doubt, please consult a qualified electrician to determine the frequency in your locale.
• When in doubt, please consult a qualified electrician to determine the frequency in your locale.