American Standard 1340.865 Manuale Utente
Certified to comply with ANSI A112.18.1M
SPOUT RECESS
Turn off hot and cold water
supplies before beginning.
supplies before beginning.
CAUTION
Assemble RUBBER WASHER (5) and BRASS WASHER (6) and
LOCKNUT (7) onto SPOUT SHANK (4). Align SPOUT ASSEMBLY.
From underside of ledge, tighten LOCKNUT (7) to secure SPOUT
ASSEMBLY to mounting surface.
LOCKNUT (7) onto SPOUT SHANK (4). Align SPOUT ASSEMBLY.
From underside of ledge, tighten LOCKNUT (7) to secure SPOUT
ASSEMBLY to mounting surface.
!
SPOUT ASSEMBLY
PREPARE TUBE AND TEE ASSEMBLY
2
3
1
1
2
1
3
5
6
1340.725
1340.825
1340.825
1340.855
1340.865
Remove COUPLING NUT (1) and FERRULE (2) from each
VALVE (3) and slide onto TUBING (4).
VALVE (3) and slide onto TUBING (4).
8"
2
7
4
MOUNTING
SURFACE
SURFACE
NOTE; Washer (5) may remain
inside of Actuator Assembly.
inside of Actuator Assembly.
SPOUT
ASSEMBLY
ASSEMBLY
MOUNTING
SURFACE
SPREAD LAVATORY
FAUCETS
FAUCETS
Installation
Instructions
Thank you for selecting American-Standard...the
benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Install RING WASHER (1) into SPOUT (2) recess. Check
that O-RING (3) on end of SPOUT SHANK (4) is in place. Insert
SPOUT SHANK (4) into center hole on mounting surface.
that O-RING (3) on end of SPOUT SHANK (4) is in place. Insert
SPOUT SHANK (4) into center hole on mounting surface.
METERING
4
1340.725
1340.825
1340.855
1340.865
1340.825
1340.855
1340.865
Plumbers' Putty or Caulking
Adjustable Wrench
2.5mm Hex Wrench
Channel Locks
TOOLS REQUIRED
REMOVE REPLACE
Remove HANDLE (1) by
removing INDEX BUTTON (2)
and SET SCREW (3) with a
2.5mm hex wrench.
removing INDEX BUTTON (2)
and SET SCREW (3) with a
2.5mm hex wrench.
Pull off HANDLE (1).
Remove ACTUATOR
ASSEMBLY (4).
ASSEMBLY (4).
Remove WASHER (5).
REMOVE HANDLE AND
ACTUATOR ASSEMBLY
ACTUATOR ASSEMBLY
1
4
5
2
3