American Standard 4233.400 Dépliant
Installation
Instructions
. 3 & 7
Certified to comply with ANSI A112.18.1M
4233.400
INSTALL FAUCET
Turn off hot and cold water
supplies before beginning.
supplies before beginning.
CAUTION
3FDPNNFOEFE5PPMT.BUFSJBMT
"EKVTUBCMF8SFODI
$IBOOFM-PDLT
3FHVMBS4DSFXESJWFS
1IJMMJQT4DSFXESJWFS
1MVNCFSTh1VUUZPS
$BVMLJOH
5VCJOH$VUUFS
Culinaire
BAR/PANTRY FAUCET
Insert supply TUBES (2) and SHANK (3) through hole of sink or
mounting surface
mounting surface
Make certain the large O-RING (1) is properly seated in recess of
faucet body.
faucet body.
Assemble RUBBER WASHER (4), BRASS WASHER (5), and thread
LOCKNUT (6) onto SHANK (3) from underside of sink. Hand tighten
LOCKNUT (6) Check that FAUCET is centered.
NOTE: Set screw is in back of faucet body.
LOCKNUT (6) onto SHANK (3) from underside of sink. Hand tighten
LOCKNUT (6) Check that FAUCET is centered.
NOTE: Set screw is in back of faucet body.
Use a screwdriver to tighten the SCREWS (7) on LOCKNUT (6).
Alternate tightening the SCREWS (7) slightly each time
until snug to ensure even pressure.
Alternate tightening the SCREWS (7) slightly each time
until snug to ensure even pressure.
RECESS
SET SCREW
(IN BACK)
1
3
2
4
5
6
7
Congratulations on purchasing your American Standard faucet with
EverClean finish found only on American Standard faucets.
EverClean finish found only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful for the life of the faucet
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel, Stainless Steel, Polished Brass (or any combination of these finishes)
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
with
EverClean™ Finish