American Standard 4101.350 Manuale Utente

M968584

Certified to comply with ANSI A112.18.1M

ALIGN SLOT 

AND TAB

ALIGN SLOT

AND TAB

SLOT

SLOT

TAB

TAB

Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD
is centered.

Assemble RUBBER WASHER (4a), BRASS WASHER (5a), and threaded LOCKNUT (6a) onto SHANK (10) from underside
of sink or mounting surface. Hand tighten LOCKNUT (6a). Use a screwdriver to tighten SCREWS (8a) on LOCKNUT (6a)
the same as fitting installation above.

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening  the
SCREWS (8) slightly each time until all are snug to ensure even pressure.

Align SOAP DISH (11) and push into place.

Apply a light bead of plumbers putty to underside of ESCUTCHEON (1) if

mounting surface is uneven.

Place ESCUTCHEON (1) onto sink or mounting surface with large opening

to the right as shown

Insert supply HOSES (2) and SHANK (3) through ESCUTCHEON (1) and mounting surface.

Make sure slot in fitting base aligns with tab on ESCUTCHEON (1). Figure 1.

Insert HOSE (9) and SHANK (10) through ESCUTCHEON (1) and mounting surface.

Make sure slot in spout base aligns with tab on ESCUTCHEON (1). Figure 2.

Adjustable Wrench

Regular Screwdriver

Phillips Screwdriver

Channel Locks