American Standard 2280 Manuale Utente

Pagina di 4
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Adjustable Wrench
Sealant
Tape Measure
Hacksaw
Wax Ring/Gasket
Flexible Supply Tube
Closet Bolts
Carpenters Level
1
   REMOVE OLD TOILET
a.
Close toilet supply valve and flush tank completely.  Towel or sponge remaining water from tank and bowl.
b.
Disconnect and remove supply line.  NOTE:
 If replacing valve, first shut off main water supply!
c.
Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.
Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: 
 Mounting surface must be clean and level before new toilet is installed!
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90
°
, and slide 
into place 6" (152 mm) apart and parallel to wall.
SAVE FOR FUTURE USE
3
2
CLOSET FLANGE
CLOSET BOLTS
7 3 0 4 5 1 - 1 0 0   R e v .   A
A
FINISHED WALL
FINISHED 
FLOOR
SUPPLY
AS
REQ'D.
Saniwares
   
CAUTION:  PRODUCT IS FRAGILE.  TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
P r o d u c t   n a m e s   l i s t e d   h e r e i n   a r e   t r a d e m a r k s   o f   A m e r i c a n   S t a n d a r d   I n c .
©   A m e r i c a n   S t a n d a r d   I n c .   1 9 9 9
 
!
NOTE:  
Pictures may not exactly define contour of china and components.
™ 
Ellisse  2184
Infinity  2316/2319
Cascada  2321/2323
Repertoire  2266/2280
Heritage 2176
Antiquity 2262/2264
Cadet 2798/2898
Reminiscence 2311
Cadet Specifier 2783/2883
ROUGHING-IN DIMENSIONS:  
NOTE: 
 Distance from wall to closet flange centerline must
be as listed below:
For 4110 Tanks:  A = 254mm (10")
For 4114 Tanks:  A = 356mm (14")
For all other Tanks:  A = 305mm (12")
A
Thank you  for selecting American Standard - the benchmark of fine quality for over 100 years.  To ensure this product 
is installed properly, please read these instructions carefully before you begin. (Certain installations may require 
professional help.) Also be sure your installation conforms to local codes.
I N S T A L L A T I O N   I N S T R U C T I O N S  
For Two-Piece Toilets with
2000
WAX RING
SEALANT
5
4
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent damage), and 
install wax ring evenly around waste flange (horn), with 
tapered end of ring facing toilet.  Apply a thin bead of 
sealant around toilet base.
POSITION TOILET ON FLANGE
a.
Unplug floor waste opening and install toilet on closet flange so bolts project
through mounting holes.
b.
Loosely install retainer washers and nuts. Side of washers marked "THIS
SIDE UP" 
must 
face up!
CLOSET
BOLT
NUT
TAPERED
WASHER
 FLANGE