Kidde 1296 Dépliant

The Kidde 1296E is a 120VAC direct wire-in smoke alarm
offering a level of protection that you have come to
expect in a Kidde product. The Kidde 1296E is designed to
alert you and your family from the dangers of smoke and
fire. This smoke alarm utilizes an ionization sensor. (For
maximum protection Kidde  recommends that both photo-
electric and ionization smoke alarm be used). The 1296E
has interconnect capabilities and can be interconnected up
to 24 Kidde devices including smoke alarms, CO alarms
and heat alarms. The 1296E includes a 9V battery backup
to provide continuous protection, even during a power
failure along with a 5 year limited warranty. The Kidde
1296E has been designed manufactured and approved to
UTHA/UTGT standards.

The Kidde 1296E 120VAC direct wire-in smoke alarm pro-
vides an early warning signal to you and your family in 
the event of a smoke or fire incident. This smoke alarm is
listed as a commercial residential multiple-station smoke
alarm and meets the UTHA sensitivity verification criteria.
The 1296E may be installed in one and two family
dwellings, lodging and rooming houses, apartment build-
ings, hotels, dormitories, day care houses, and residential
board and care facilities. This smoke alarm is equipped
with two test buttons. Test button A is used for testing the
unit’s electronic circuitry, horn and battery. Test button B
tests the alarms sensor sensitivity

• UTHA/UTGT Compliant – Meets the sensitivity 

verification criteria outlined in NFPA 72 and may be 
installed in one and two family dwellings, lodging and 
rooming houses, apartment buildings, hotels, 
dormitories, day care homes, and residential board and 
care facilities.

• Two Test Buttons – Verifies alarm operation and 

sensitivity verification.

• Interconnectable System – Interconnects with up to 

24 Kidde devices (of which 18 can be initiation) 
including smoke, co and heat alarms.

• 9V Battery Backup – Provides protection even during 

power failures.

• Alarm Memory – Informs you if the alarm has 

sounded since the test button was last pressed.

• Tamper Resist – Helps prevent someone from 

tampering with or removing smoke alarm from 
mounting bracket.

• Separate Trim Ring – Fits all standard electrical box 

configurations.

Tests the alarms sensor sensitivity 

Tests the units electronic circuitry, horn and battery 

Fits all standard electrical box configurations