Panasonic SC-ZT2 Manuale Utente

VQT2R70

When the speakers are detected, the Wireless Link display lights up on the main unit’s display.
(Blinks during detecting operation.)
While the wireless speakers operate normally, the Wireless Link display lights, but when radio 
waves are interrupted (When speakers are in Standby condition, etc.), it blinks.

Display

Wireless Link 
display

•  The optional speakers can be purchased at the shop where you bought 

this system.

•  Confirm the color of the front speaker before buying the optional 

speakers.

When the front speaker is black: SB-ZT2PP-K
When the front speaker is silver: SB-ZT1PP-S

•  Place them slightly at the back right and left of the listening-viewing 

position.

•  There is no positional distinction for each speaker before setting.
•  Aim the front face (with Panasonic logo) of each speaker at the listening-

viewing position for setting.

Set the distance from each speaker to the listening-viewing position. 
(➜ page 22)

The test signal is output from one speaker at a time for about 2 seconds in the order shown below.
“

TEST L ” 

→ “TEST R ” → “TEST RS ” 

✽

 

→ “TEST LS ” 

✽

„

Front left

Front right

✽

Surround right (right back)

✽

Surround left (left back)

If the speakers are not properly set, do either of the following.
•  Move the speakers according to the unit’s display.
• Perform steps 

3 and 4 of “Setting the speakers” (➜ page 13). When using the surround speakers, perform steps 7 and 8 of 

“Setting surround speakers” (

➜ page 15).

  If the speaker is repaired or replaced
Perform the above “Checking the speaker setting” to confi rm that the speaker properly operates. 
Do the following operations if the sound is not produced normally:
1. Press and hold [INPUT SELECTOR] on the main unit about 3 seconds until “

2CH SEARCH ” is displayed.

2. Perform steps 

2 to 4 of “Setting the speakers” (➜ page 13).

You can enjoy more dynamic surround playback with this system by installing Panasonic surround speakers SB-ZT1/SB-ZT2.

•  When you turn the main unit off with the speakers on, the speakers automatically enter Standby (Wireless Link Standby). The 

color of the [WIRELESS LINK] indicator turns to red.

•  To reduce more of the power consumption of speakers in Standby, turn the speakers off. The speakers enter Standby (In Standby condition).
<Power consumption of speakers in Standby>
  Wireless Link Standby: approx. 0.8 W (per 1 speaker)
  In Standby condition: approx. 0.1 W (per 1 speaker)

✽  Displayed only when using the surround speakers.

Press

•  To adjust the speaker volume, press [VOL        +, –].

Front speaker 
(right)

Front speaker 
(left)

Connected equipment

Main unit

Surround 
speaker 
(left)

Surround 
speaker (right)

Approx. 120°

5%<622 8364'PKPFF

5%<622 8364'PKPFF

ඦ೨

ඦ೨