ONKYO 29344934 Manuale Utente

41

Note:
When the room correction and speaker setup is 
complete, “6. Equalizer” (page 72) will be set to 
“Audyssey.”

While the room correction and speaker setup is in 
progress, one of the following error messages may 
appear:

❏ Ambient noise is too high

This message appears if there’s too much background 
noise and the measurements cannot be performed 
properly. Remove the source of the noise and try again.

❏ Speaker Detect Errors

This message appears if one of the speaker-related errors 
below occurs.
• One of the front speakers has not been detected.
• One of the surround speakers has not been detected.

❏ Write Error

This message appears if saving fails.

❏ Mismatch Error

This message appears if a speaker that was detected 
during the 1st measurement is not detected during the 
2nd or 3rd measurements. If this message appears, check 
your speaker connections, and then try again.

If you wish to make changes to the settings found during 
the room correction and speaker setup, follow the 
directions on pages 70–72.

If you’re using a powered subwoofer, as it outputs very 
low-frequency sound and its position is usually low 
down, it may not be detected by the Audyssey 2EQ 
Room Correction and Speaker Setup. In this case, 
increase the subwoofer’s volume, select its highest 
crossover frequency, and then try running the 
Audyssey 2EQ Room Correction and Speaker Setup 
again. Note that if the volume is set too high and the 
sound distorts, it may not be detected, so use an 
appropriate volume level.

c

 (page 39), and 

Audyssey 2EQ

™

 performs more 

measurements.
This takes a few minutes.

When the measurements are complete, the 
results are calculated and saved automatically.

Press the [ENTER] button.
Make sure speakers that cannot be 
detected are connected properly.

HT-S5200_En.book  41 ページ  ２００９年３月９日　月曜日　午後４時３１分