NEC Projector User Supportware 2 Manuale Utente
24
4. Preparation of the Projectors
Prepare the projectors to be used for stacking/tiling correction. In addition to the explanations in this manual, also
refer to the projectors' operating instructions.
refer to the projectors' operating instructions.
1. Install and connect the projectors that will be
used, and project them onto the screen (The
portion of projectors that will be used)
portion of projectors that will be used)
Connection of the Equipment Page
Tiling correction only
• Please adjust the projection positions so that the
• Please adjust the projection positions so that the
projected image of each projector overlaps by 15% or
more.
more.
2. Adjust the Projectors
Refer to the projector user's manual and perform the fol-
lowing adjustments.
lowing adjustments.
Adjustments for both stacking and tiling correction
• Adjust so that the projection image of each projector enters the screen.
• Set [ECO MODE] to the same setting for each of the projectors.
• Make image quality adjustments, projection position adjustments, and zoom and focus adjustments as re-
• Set [ECO MODE] to the same setting for each of the projectors.
• Make image quality adjustments, projection position adjustments, and zoom and focus adjustments as re-
quired.
Adjustments for stacking correction only
• When correcting the stacking to match the projected screen of the master projector using the web camera,
please carry out [CORNERSTONE] for the projector that is going to be the master. When the projected image
of the master projector is distorted, the stacking of the other projectors will also be corrected to match the dis-
torted projection image.
of the master projector is distorted, the stacking of the other projectors will also be corrected to match the dis-
torted projection image.
Reference
• When [Auto] instead of [Master Projector] is selected in the calibration mode, the [CORNERSTONE] of all the
projectors will be reset before performing the correction.
• When [Auto] is selected in the calibration mode, correction will be applied on all the projectors. Please specify the
projectors which you do not wish to correct in [Master Projector].