NEC PX602WL-BK Manuale Utente
6
1. Introduction
Rear
Stacking holder fixing position
(3 positions)
For stacking up the projectors, fas-
ten up the stacking holders supplied
with this projector.
(3 positions)
For stacking up the projectors, fas-
ten up the stacking holders supplied
with this projector.
Safety cover fixing hole
(7 positions)
The fixing holes for installing the
safety cover (sold separately) that is
used for portrait installation.
Remote Sensor (located on the
front and the rear)
(
front and the rear)
(
→ page
AC IN terminal
Connect the supplied power cord’s
three-pin plug here, and plug the
other end into an active wall outlet.
(
Connect the supplied power cord’s
three-pin plug here, and plug the
other end into an active wall outlet.
(
→ page
Main power switch
While AC power is being supplied,
set the main power switch to ON
position (|), then your projector will
enter a standby state.
While AC power is being supplied,
set the main power switch to ON
position (|), then your projector will
enter a standby state.
* This security slot supports the MicroSaver
®
Security System.
Built-in Security Slot ( )*
Security Bar
Attach an anti-theft device.
The security bar accepts security
wires or chains up to 0.18 inch/4.6
mm in diameter.
Adjustable Tilt Foot
(
→ page
Intake vent
Takes in outside air to cool the unit.
There are air intake and ventilation
holes on the bottom.
(
Terminals
(
(
→ page
)