Runco X-200i Manuale Utente
Runco X-200i Series Installation/Operation Manual
35
PRE
L
IMINAR
Y
Connecting the Active 3D
Emitter to the Projector
Emitter to the Projector
Connect the 3D SYNC IN port on the emitter to the 3D SYNC connector on the
projector, as shown in Figure 3-17.
projector, as shown in Figure 3-17.
Figure 3-17. Active 3D Emitter Connection
Connecting to AC Power
Projector: The X-200i ships with various types of AC power cords. Choose the one that
is appropriate to your locale.
is appropriate to your locale.
Plug the female end of the power cord into the AC receptacle on the rear of the projector
(AC 100V ~ 240V); see Figure 2-2. Then, connect the other end to your AC power source.
(AC 100V ~ 240V); see Figure 2-2. Then, connect the other end to your AC power source.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to your AC power
source.
Secure the emitter in the desired location using double-sided tape or
a similar adhesive material.
a similar adhesive material.
Tip
3D SYNC
3D SYNC
RS-232
USB
USB
COMPONENT 1
COMPONENT 1
12V TRIGGER
I
II
12V TRIGGER
WIRED REMOTE
WIRED REMOTE
POWER
SOURCE
SOURC
POWER
ISSUE
ISSUE
POWER
POWER
LED STATUS
LED STA
TUS
RS-232
USB
USB
COMPONENT 1
COMP
ONENT
1
12V TRIGGER
I
II
12V TRIGG
ER
WIRED REMOTE
WIRED REM
OT
E
POWER
SOURCE
SOURC
POWER
ISSUE
ISSUE
POWER
POWER
LED STA
T
T TUS
A
A
LED STA T T
TUS
A A
3D
SYNC IN