Shark SV736R Manuale Utente

1. This cordless vacuum is powered by 

rechargeable nickel-cadmium 
batteries. Before using the vacuum, 
charge the vacuum cleaner for a 
minimum of 20 hours.
NOTE: Ensure that the On/Off 
switch is in the “Off” position 
before charging.

Note: Dust cup filter must always be 
used when operating the hand 
vacuum.
1. To open the dust cup compartment, 

push the dust cup release button 
and  remove the dust cup 
container. (Fig. 2)

2. Verify that the dust cup filter is 

inside, then re-attach the dust cup 
container to the hand vacuum. 
(Fig. 3)

NOTE: Peak performance may only 
be realized after the unit has been 
charged and discharged two (2) or 
three (3) times.

IMPORTANT: To maintain peak 
performance of your cordless hand 
vacuum, it is recommended that the 
unit be fully discharged, then 
completely re-charged at least once a 
month.

3.  To attach the crevice tool to the 

hand vacuum, push the attachment 
into the suction hole in the front of 
the dust container. (Fig. 4)

Fig. 2

Fig. 3

2. Connect the charging jack to the 

charging hole that is on the back of 
the unit.

3. Plug the charger into wall outlet.
4. The charging indicator light 

will shine green to indicate that the 
vacuum cleaner being charged. 
(See Fig. 1)

Fig. 1

Fig. 4

1. To start the unit, push the "On/Off" 

switch to the "On" position.

2. To stop the vacuum cleaner, slide 

the "On/Off" switch to the "Off" 
position.

3. A crevice tool is provided for 

cleaning narrow, hard to reach 
places. 

To achieve the best performance, 
empty the dust cup container and 
clean the dust cup filter after each use.
1. To remove the dust cup container, 

press down on the dust cup release 
button and pull off  the dust cup 
container.

2. Pull out the dust cup filter.
3. Empty the dust from the dust cup 

container. (See Fig. 7)

4. Rinse the dust cup filter in cold water, 

and then wait until it dries completely 
before replacing it back into the dust 
cup container. Do not use a washing
machine to clean the dust cup filter. 
Do not use a hair dryer to dry it. Air 
dry only. 

5. Replace the dust cup filter carefully 

into the dust cup compartment. 
NEVER operate vacuum cleaner 
without dust cup filter in place.

6. Attach the dust cup container to the 

cordless vacuum.

: The suction hole must be 

open and free of any obstructions at all 
times. Otherwise, the motor will 
overheat and could become damaged.

: It is recommended that the 

dust cup filter be replaced every three 
(3) months to ensure peak performance 
of the unit.

: NEVER use ordinary 

batteries for replacement, as these may 
leak and damage your vacuum cleaner.

Fig. 7

1. Make sure that the “On/Off” switch 

is in the "Off“ position.

2. Firmly insert the motorized brush  

(Fig. 5) into the air-intake nozzle of 
the dust cup container ensuring 
that the contact pins are engaged 
in the connector slots of the unit. 
(Fig. 6)
Please note that this motorized 
brush is for vacuuming short pile 
carpets or rugs.

Fig. 6

Fig. 5

Metal 

contact

pins