Honeywell TH8110U Manuale Utente

Pagina di 12
® U.S. Registered Trademark
Copyright © 2004 Honeywell International Inc.  •  
  • All Rights Reserved 
INSTALLATION INSTRUCTIONS
69-1700
TH8110U Touch Screen
Programmable Thermostats
APPLICATION
The TH8110U Universal Programmable Thermostats provide electronic control of 24 Vac heating and cooling systems 
or 750 mV heating system. See Table 1 for a general description.
RECYCLE NOTICE
If this control is replacing a control that contains 
mercury in a sealed tube, do not place your old 
control in the trash. Dispose of properly.
Contact your local waste management authority 
for instructions regarding recycling and the 
proper disposal of the old control.
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow 
the instructions can damage the product or cause 
a hazardous condition.
2. Check the ratings given in the instructions to make 
sure the product is suitable for your application.
3. Installer must be a trained, experienced service 
technician.
4. After completing installation, use these instructions 
to check out the product operation.
Selecting Location
Install the thermostat about 5 ft. (1.5m) above the floor in 
an area with good air circulation at average temperature. 
See Fig. 1. 
Fig. 1. Selecting thermostat location.
Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall 
behind the thermostat.
Table 1. TH811 Thermostats Description.
Model
Power 
Method
Changeover
System Selection
Fan Selection
Comments
TH8110U
Batteries or 
common wire
Automatic or 
manual 
selectable
Heat-Off-Cool-Auto 
On-Auto-Circ
System and Fan 
selection vary based on 
system type
5 FEET
[1.5 METERS]
YES
NO
NO
NO
M19925