Euro-Pro 1104HV Manuale Utente

1. Turn the hand wheel to raise up the 

needle to the highest position. Lift the 
presser foot and place the fabric to be 
sewn under the presser foot. (Fig. 1)

2. Lower the presser foot. (Fig. 2)
3. Press the On/Off button to the “On” 

position and begin sewing.  Do not 
pull the fabric. Gently guide the fabric 
to keep the seam straight. (Fig. 3)

4. After finishing sewing, press the 

On/Off button to the “Off” position to 
stop sewing. (Fig. 3)

5. Turn the hand wheel to raise the 

needle to the highest position. Lift the 
presser foot and gently remove the 
fabric away from the sewing machine. 
(Fig. 4)

6. Cut the thread using the thread cutter. 

(Fig. 5) 

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Before sewing your garment, test for the correct stitch length using a piece of fabric.
You can select from three different (3) stitch lengths for sewing and three (3) for 
reverse sewing. To select the stitch length:
1. Turn the stitch length adjustment dial all the way to the left for the longest stitch 

length.  This is recommended for normal sewing.

2. As you turn the dial to the right, you decrease the length of the stitch until you get 

to the center point which is “0” length.  The needle will remain stationary if you set 
the dial at this point.

3. As you continue to turn the dial to the right, you will now set the sewing machine 

into reverse sewing.  Again, you have three (3) different stitch lengths for reverse 
sewing, the farthest to the right being the longest.

4. Use reverse sewing to secure your stitches at the beginning of your seam and at 

the end.  This will strengthen your seams.

Caution: Do not sew at “0” stitch length as this will cause your machine to get stuck.

If additional light is needed, press the light 
switch to turn the light “On”.   Press the switch 
again to turn it “Off”.