Husqvarna C10 Manuale Utente

4. Pull the thread down between the tension discs.

5. Then, down and around the check spring holder and

back up to the take up lever.

6. Pull the thread from right to the left through the slotted

eye of the take-up lever and then down again.

7. Pass the thread behind the fl at, horizontal thread

guide.

8. Guide the thread into the wire loop.

9. Thread the end of the thread through the needle from

front to back, and pull out about 10 cm of thread.

Or use the needle threader to thread the needle. (On
the next page).