Winegard HD-1080 Dépliant

Printed in U.S.A.  © Winegard Company 2009 • Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000 Rev7 12-13  1450510

Step 1.  Remove antenna from carton. Unfold elements and reflectors. Make sure that they are straight and perpendicular to  

 

the boom.

Step 2.  Attach mast clamp to the back boom (larger antenna section) antenna using the screw and hex nut supplied, Fig. 2. 
Step 3.  Using the bolts and hex nuts provided, attach the smaller section to the larger section of the antenna using the   

 

spacers as shown in Figure 1.

Step 4.  Mount antenna on top of mast and lightly tighten mast clamps.
Step 5.  On the back of the smaller section, line up the two phasing lines and insert the smaller screws from the hardware bag  

 

so that the head of each screw faces the larger section of the antenna. Place two washers on each screw and install  

 

the nut to hold the washers in place DO NOT TIGHTEN. Connect matching transformer to the downlead connection. 

 

Slide spade lugs of matching transformer between the washers. Tighten hex nuts securely. With the screws in place,  

 

connect the coax downlead to the matching transformer on the antenna, but do not secure at this time. Then    

 

connect the coaxial cable to your TV.

Step 6.  Point front of antenna towards stations and tighten mast clamp securely, Figure 1.
Step 7. Secure coaxial downlead to the mast using tape to prevent whipping by the wind.
Step 8. Ground antenna and mast per accompanying Safety Instruction sheet.