Multiquip LS600P Manuale Utente

1.  Locate the 

emergency stop switch (Figure 20) on 

the 

digital control panel. Turn the emergency stop 

switch clockwise and release (open). This will allow 

the engine to start.

2.  Place the 

cylinder stroke control switch in the 

aUTOMaTiC position (Figure 21).

3.  Place the 

pumping control switch in the CENTER 

OFF position (Figure 22) for normal pumping operation.

DO NOT attempt to operate this concrete pump until 

the Safety, General Information and Inspection sections 

have been read and understood.

E

m

erg

ency S

top

If the 

emergency stop switch is in the closed position 

(

STOP), engine will not start. To start the engine, make 

sure the emergency stop switch is in the 

OPEN position 

(fully extended).

AUTOMATIC

JOG

LOCAL

REMOTE

CENTER

OFF

4.  Place the 

direction control switch to the FORWARD 

position (Figure 23).

5.  To start the engine, insert the ignition key (Figure 24) 

into the ignition switch and turn the key to the 

ON 

position.

6.  When the ignition key is in the 

ON position, the digital 

readout screen (primary) will cycle through 3 displays 

as shown in Figure 25.

7.  Turn the key to the 

START position and listen for the 

engine to start. In warm weather let engine warm up 

for 5 minutes. In cold weather, let engine warm up for 

10 minutes.

FORWARD

REVERSE

IGNITION

ON

OFF

START

LS  600  OFF

0000 ENG RPM

BATTERY 12.5 V

LOW OIL PSI

1

LS 600  OFF

0000 ENG RPM

BATTERY 12.5 V

LOW RPM FAULT

1

LS  600  OFF

0000 ENG RPM

BATTERY 12.5 V

END OF MESSAGE

1