Viking SLBL Manuale Utente
fIGURE 125
fIGURE 126
fIGURE 122
8.06
8.10
fIGURE 123
8.03
8.04
fIGURE 124
8.02
8.01
2.01
SECTION TSM 288
ISSUE
A
PAGE 30 OF 36
5.6 ROTaRY sEal REMOVal
• To remove the seal face in the rotor use the seal face
removal tool
• The tool locates on the rubber L-cup and when pressed in
the seal face will extrude up into the tool allowing ease of the
seal face removal (A press tool may be required)
• Install the O-ring (8.06) into the seal housing and then install
the seal housing (8.10) into the casing
• making sure that the location recesses line up with the seal
washers (8.08) (See Figure 47 and Figure 44)
• Install the O-ring (8.04) onto the static seal (8.03) and then
install the static seal into the casing – make sure that the
location slots line up with the pins in the seal housing
• Install the L-cup (8.01) and the rotary face (8.02) into the
rotor (2.01)
The seals are now assembled.
For rotor and head installation see pump assembly section.
For rotor and head installation see pump assembly section.