Line 6 headphones powered monitors Manuale Utente

 

 

Line 6 GearBox 3.1 – Basic Features Guide

 

 

 

 

 

 
 

 

 

 

 

 

 

Connect your 
stereo Headphones  

Connect up to two 
Microphones  

Connect your electric Guitar or Bass 

 
 
Microphone Inputs - You can receive input from one or two mics at the same time using these 
ins. There is also a +48V Phantom Power switch that you should toggle to “on” if your mic 
requires phantom power (most condenser type mics do, but check the documentation for your mic 
if you are not sure).  Connect each mic using an XLR cable. This inputs each microphone signal 
independently into GearBox where you can choose your tone, and then route the processed signal 
both to your audio software and out the TonePort outputs. 
 
Guitar/Bass Inputs -To input your electric guitar or bass, plug it into one of these inputs. Either 
of these routes the instrument’s signal into GearBox where you can choose your tone and route 
the processed signal both to your audio software and out the TonePort outputs. 
Norm – this input is for a standard instrument level output. Plug your guitar/bass into here using a 
standard 1/4-inch TS instrument cable. 
 
Pad - this input is designed for high output level basses and guitars, especially those with active 
pickups. Plug your high output instrument into here using a standard 1/4-inch TS instrument 
cable. 
 
Headphone - If you want to listen to the audio from TonePort using stereo headphones, then plug 
them into this 1/4-inch stereo jack. This Headphone jack outputs the same signal fed to the 
Analog Outs on the rear panel of TonePort; the audio from your audio software on the computer, 
as well as anything plugged into any TonePort input. 

 

Page 30