3com 3CRUS2475 Manuale Utente

The spanning-tree link-type Interface Configuration mode command 
overrides the default link-type setting determined by the duplex mode of 
the port and enables Rapid Spanning Tree Protocol (RSTP) transitions to 
the forwarding state. To restore the default configuration, use the no 
form of this command.

spanning-tree link-type {point-to-point | shared}

no spanning-tree spanning-tree link-type

■

point-to-point —Indicates that the port link type is point-to-point.

■

shared — Indicates that the port link type is shared.

The device derives the port link type from the duplex mode. A full-duplex 
port is considered a point-to-point link and a half-duplex port is 
considered a shared link.

Interface Configuration (Ethernet, port-channel) mode

There are no user guidelines for this command.

The following example enables shared spanning-tree on Ethernet port 
g15.

The spanning-tree pathcost method Global Configuration mode 
command sets the default path cost method. To return to the default 
configuration, use the no form of this command.

Console(config)# interface ethernet g15

Console(config-if)# spanning-tree link-type shared