Axor 38000XX1 Manuale Utente
3
Installation Instructions
Flush the supply lines thoroughly before installation.
If the mounting surface is 3/16"thick or less, cut the centering
ring so that it is as thick as the countertop. If the mounting
surface is greater than 3/16", leave the centering ring intact.
•
Place the faucet and centering ring in position on the
mounting surface.
•
From underneath the mounting surface, slip the
fixation piece over the threaded pin. Tighten the nut.
•
Attach the supply hoses to the supply stops. The hot
hose is marked with a red band.
•
The supply hoses included with this faucet will fit a
standard supply stop with a 3/8" compression fitting
(not included). Remove the compression nut and ring
from the stop. Slide them over the hose inlet.
•
Insert the hose into the stop. Hand tighten the nut.
Use a wrench to tighten the compression nut fully.
Turn on the supply stop to check for leaks.
•
Install the pop-up drain. Install the pull rod and connect to the drain assembly.