Axor 14870001 Manuale Utente

4

Remove the plastic washer, fiber washer, friction washer, 

and mounting nut from the faucet.

If the mounting surface is thicker than 1 /8”, or if there 

is insufficient space, discard the plastic washer.

From below the mounting surface, install the plastic wash-

er (if using), fiber washer, and friction washer.  Install the 

mounting nut, but do not tighten it completely.

Inspect the placement of the faucet.  Reposition if neces-

sary.

When satisifed, finish tightening the mounting nut.  

Tighten the tensioning screws.

Connect the hoses to the stops using /8” compression 

fittings (not included).  Use two wrenches, as shown in 

the diagram, to prevent the hoses from twisting or from 

becoming loosened from the faucet.  

For proper operation of the faucet, the hot supply should 

be on the left, and the cold supply should be on the right.  

fiber washer

friction washer

mounting nut

tensioning 

screws

fiber washer

friction washer

mounting nut

tensioning 

screws

plastic washer