Axor 06698XX0 Manuale Utente

4

Proper installation of the hose weight will insure 

that the handspray retracts smoothly.
On the handspray side of the hose, measure 15” 

down from the body of the faucet.  Install the 

weight at this point.
Pull out on the handspray.  It should move easily 

and retract smoothly.  Reposition the weight as 

necessary.
Make sure that the hot and cold supply hoses do 

not interfere with the handspray hose.  They can 

be repositioned slightly if necessary.

Install the Boltic™ handle screw on the stem.  

Tighten only 4 turns.
Place the handle over the stem and handle 

screw.  Press the handle firmly into place.
Use the 4mm hex wrench to finish tightening 

the screw.
Install the screw cover.

Connect the handspray hose to the handspray sup-

ply hose with the nut, cone washer, flat brass washer 

and rubber washer as shown.