Pioneer CT-W208R Manuale Utente

17

÷   Clean the head (see page 5).

÷   Completely fast-forward or rewind the tape.

Unstable or inter-
rupted sound.

No high frequen-
cies.

÷   The head, pinch rollers and capstans are

÷   The tape is not uniformly wound.

÷   Set the DOLBY NR switch to OFF.

÷   Clean the head (see page 5).

÷   The head is dirty.

Sound from previ-
ous recordings
remains when
rerecording a tape.

The sound is dis-
torted.

Too much noise.

÷   Replace the cassette.

÷   Check connections (see page 7).

÷   Turn REC LEVEL control up when record-

ing (see page 14).

÷   Clean the head (see page 5).

÷   Demagnetize with a head demagnetizer

(see page 5).

÷   High noise tape is being used.

÷   Incomplete insertion of a connection

cord, poor contact.

÷   Recording level is too low.

÷   The head is dirty.

÷   The head is magnetized.

÷   Clean the head (see page 5).

÷   Turn REC LEVEL control down when

recording(see page 14).

÷   Replace the cassette.

÷   Clean the head (see page 5).

÷   Recording level is too high.

÷   The recorded signal itself is distorted.

÷   The head is dirty.

÷   A tape recorded without Dolby NR is

being played back with the DOLBY NR
switch in the B or C position.

÷   The head is dirty.

High frequencies
are
emphasized.

÷ A Dolby NR-encoded tape is being played

back with the DOLBY NR switch in the
OFF position.

÷   Set DOLBY NR (B/C) switch to the same

position used for recording.

÷   The remote control cord is not connected.

÷ Blanks between selections are less than 4

seconds long.

÷   Connect the remote control cord

(see page 7).

÷   Use a tape with blanks more than 4

seconds long.

The music search
function does not
work.

C a n n o t   u s e   t h e
r e m o t e   c o n t r o l
system.

Abnormal functioning of this unit may be caused by static electricity, or other external interference. To restore normal op-
eration, turn the power off and then on again, or unplug the AC power cord and then plug it in again.