Aiko CTH3-200 Manuale Utente
CTH3-S
ERIES
I
NSTALLATION
, O
PERATION
AND
S
ERVICE
M
ANUAL
10 of 71
SECTION 5: MAJOR COMPONENTS
FIGURE 13: Major Component Descriptions
Burner with Tube Gasket
Must be installed with the
flame observation
window facing down.
window facing down.
Reflector
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview and
on Page 15, Figure 16.
Minimum overlap is 6" (16 cm).
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview and
on Page 15, Figure 16.
Minimum overlap is 6" (16 cm).
Tube and Reflector Hanger
with Clamp Package
Position this hanger no more
than 4" (10 cm) away from the
burner.
with Clamp Package
Position this hanger no more
than 4" (10 cm) away from the
burner.
Coupling Assembly
with Lock
with Lock
Reflector End Cap
Punch out center
section to
accommodate tube.
Punch out center
section to
accommodate tube.
Tube and Reflector Hanger
Suspend system from these
hangers.
Suspend system from these
hangers.
Flex Gas Line with
Shut Off Cock
Shut Off Cock
Tube
Heat treated
aluminized tube supplied
in 10' (3 m) lengths.
Heat treated
aluminized tube supplied
in 10' (3 m) lengths.
Burner Tube
Supplied in 10
Supplied in 10
'
(3 m) lengths. Burner
tube is always the first tube
after the burner.
tube is always the first tube
after the burner.
Reflector Support Strap &
Wire Form
Wire Form
Turbulator
Turbulator must
be installed in the last
standard section of tube.
Turbulator is not required on the
CTH3-200. For installation
be installed in the last
standard section of tube.
Turbulator is not required on the
CTH3-200. For installation
Vent Adapter