Aiko CTH3-200 Manuale Utente

1 of 71

Your Safety is Important to Us!
This symbol is used throughout 
the manual to notify you of possi-
ble fire, electrical or burn hazards. 
Please pay special attention when 
reading and following the 
warnings in these sections.

Installation, Service and Annual Inspection of heater 
must be done by a contractor qualified in the 
installation and service of gas-fired heating 
equipment.

Read this manual carefully before installation, 
operation or service of this equipment.

This heater is designed for heating nonresidential 
indoor spaces. Do not install in residential spaces. 
These instructions, the layout drawing, local codes 
and ordinances, and applicable standards that apply 
to gas piping, electrical wiring, venting, etc. must be 
thoroughly understood before proceeding with the 
installation.

Protective gear is to be worn during installation, 
operation and service. Thin sheet metal parts, 
including the aluminum reflector portion of the heater 
and the various venting components, have sharp 
edges. To prevent injury, the use of work gloves is 
recommended. The use of gloves will also prevent 
the transfer of body oils from the hands to the surface 
of the reflector.

Before installation, check that the local distribution 
conditions, nature of gas and pressure, and 
adjustment of the appliance are compatible.

This heater must be applied and operated under the 
general concepts of reasonable use and installed 
using best building practices.
This appliance is not intended for use by persons 
(including children) with reduced physical, sensory or 
mental capabilities, or lack of experience and 
knowledge, unless they have been given supervision 
or instruction concerning use of the appliance by a 
person responsible for their safety. Children should 
be supervised to ensure that they do no play with the 
appliance.

For additional copies of the Installation, Operation 
and Service Manual, please contact Roberts-Gordon 
LLC.

To prevent personal injury and damage to the heater, 
two persons will be required for installation.

Product safety signs or labels should be replaced by 

the product user when they are no longer legible. 
Please contact Roberts-Gordon LLC or your ROB-
ERTS GORDON

®

 independent distributor to obtain 

replacement signs or labels. 

See Page 2, Figure 1 

through Page 3, Figure 2.

In accordance with California Proposition 65 require-
ments, a warning label must be placed in a highly 
visible location on the outside of the equipment (i.e., 
near equipment’s serial plate). See label placement 
drawing 

on Page 2, Figure 1 for label location. Avoid 

placing label on areas with extreme heat, cold, corro-
sive chemicals or other elements. To order additional 
labels, please contact Roberts-Gordon LLC or your 
ROBERTS GORDON

®

 independent distributor.