Yamaha RX-V3800 Manuale Utente

You can program remote control codes from other remote 
controls. Use the learn feature if you want to program 
functions not included in the basic operations covered by 
the remote control codes, or an appropriate remote control 
code is not available. You can program the function of 
other remote control to the buttons in the highlighted areas 
in the following illustration. The buttons can be 
programmed independently for each input area.

The remote control transmits infrared rays. If the other remote 
control also uses infrared rays, this remote control can learn most 
of its functions. However, you may not be able to program some 
special signals or extremely long transmissions. Refer to the 
operating instructions for the other remote control.

D

SOURCE

1

Make sure that the operation mode selector is set to D

. 

When you set the operation mode selector to D

 and 

program a remote control codes from other remote controls, the 
programmed key cannot operate the amplifier function of this 
unit.

M

LEARN

“LEARN” and the name of the selected input area 
(ex. “DVD”) appear alternately in the display window 
(B) on the remote control.

• Do not press and hold M

. If you hold it down for 

more than 3 seconds, the remote enters the remote control 
code setting mode.

• If you do not complete each of the following steps within 

30 seconds, the learning mode will be automatically 
canceled. In this case, start over from step 3.

“LEARN” appears in the display window (B) on the 
remote control.