Yamaha RX-V463 Manuale Utente
21
En
Connections
English
PREP
ARA
TION
1
Press A
STANDBY/ON on the front panel to
set this unit to the standby mode.
Refer to the right column for details.
Refer to the right column for details.
2
Press and hold K
TONE CONTROL and
then press A
STANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Press L
PROGRAM l / h to select “SP
IMP.”.
“SP IMP.” and the current speaker impedance setting
(“8
“SP IMP.” and the current speaker impedance setting
(“8
Ω MIN”) appear in the front panel display.
4
Press M
STRAIGHT repeatedly to select
“6
Ω MIN”.
5
Press A
STANDBY/ON to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this unit.
■ Turning on this unit
Press A
STANDBY/ON (or HPOWER) to turn
on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press A
STANDBY/ON (or ISTANDBY) to set
this unit to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6
If you are to use 6 ohm speakers, set “SP IMP.” to
“6
Ω MIN” as follows BEFORE using this unit.
Note
TONE CONTROL
STANDBY
/ON
While holding
down
Turning on and off the power
01EN_RX-V463_U.book Page 21 Friday, February 1, 2008 11:43 AM