Yamaha RX-A2010 Manuale Utente

En

Configures the audio output settings.

■ 

Adjusts the delay between video and audio output.

❑ Auto

Adjusts the delay between video and audio output automatically when a TV that 
supports an automatic lipsync function is connected to this unit via HDMI. If necessary, 
you can fine-adjust the audio output timing. “Offset” shows the difference between 
automatic adjustment and fine adjustment.

Setting range
0ms ~ 500ms (1ms steps)

Default
0ms

❑ Manual

Adjusts the delay between video and audio output manually.

Setting range
0ms ~ 500ms (1ms steps)

Default
0ms

■ 

Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and 
DTS signals) playback.

■ 

Sets the maximum volume so that sound is not too loud.

Setting range
-30.0dB ~ +15.0dB (5.0dB steps), +16.5dB

Default
+16.5dB

■ 

Sets the initial volume for when this receiver is turned on.

■ 

Selects whether to output video signals during the Pure Direct mode (p.58).

Maximum (default)

Produces audio without adjusting the dynamic range.

Standard

Optimizes the dynamic range for regular home use.

Minimum/Auto

Sets the dynamic range to make clear sound even at night or at low 
volumes.
When playing back Dolby TrueHD signals, the dynamic range is 
automatically adjusted based on the input signal information.

Off (default)

Sets at the level when this unit last entered standby mode.

On

Sets at Mute, or -80.0dB ~ +16.5dB (0.5dB steps). (This setting works 
only when “Max Volume” is set higher.)

Auto (default)

Automatically outputs video signals when any videos are input from the 
selected input source or an input source that can be operated with the 
on-screen display is selected. When no video signals are input, the wall 
paper is displayed.

Video Off

Does not output video signals including the wall paper.