ONKYO HT-R368 Manuale Utente

■

`

`

Auto:

The audio signal from your TV tuner can be sent to 
the HDMI OUT of the AV receiver.

The audio return channel (ARC) function allows an ARC 
capable TV to send the audio stream to the HDMI OUT of 
the AV receiver. To use this function, you must select the 
TV/CD input selector and your TV must be ARC capable.

• This setting is fixed to “- - - -” when the “HDMI Ctrl (RIHD)” 

setting is set to “Off”.

• This setting is set to “Auto” automatically when the “HDMI Ctrl 

(RIHD)” setting is set to “On” for the first time.

• If you set “Audio Return Ch” to “Auto”, the “Audio Selector” 

settings of the TV/CD input selector will be automatically 
switched to “ARC” (

).

■

`

`

On 

This function allows the AV receiver to automatically 
correct any delay between the video and the audio, based 
on the data from the connected monitor.

• This function works only if your HDMI-compatible TV supports 

HDMI Lip Sync.

You can change various audio settings from the Home 
menu (

).

• These settings are not available in either of the following cases:

– The  “Audio TV Out” setting is set to “On” (

– “HDMI Ctrl (RIHD)” is set to “On” (

) and you’re 

listening through your TV speakers.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut low-frequency sounds output 
from the front speakers.

■

`

–10 dB to 0 dB to +10 dB in 2 dB steps

You can boost or cut high-frequency sounds output 
from the front speakers.

You can adjust the bass and treble for Speakers A and B 
front speakers, except when the Direct listening mode is 
selected.

• Alternatively, you can use the AV receiver’s TONE and –/+.

■

`

–15 dB to +3 dB to +12 dB in 1 dB steps

■

`

–12 dB to 0 dB to +12 dB in 1 dB steps

You can adjust the volume of each speaker while listening 
to an input source.
These temporary adjustments are cancelled when the AV 
receiver is set to standby. To save the setting you made 
here, go to “Level Cal (Level Calibration)” (

) 

before setting the AV receiver to standby.

• These settings cannot be calibrated in either of the following 

cases:
– A pair of headphones is connected.
– The AV receiver is muted.

• Speakers that are set to “No” or “None” in the “Sp Config 

) cannot be adjusted.

■

`

`

On 

EX.BASS is a technology that have developed by 
experiments and listening tests to reproduce a natural 
deeper bass. When you turn the mode on, you can get 
dynamic and deeper presence on your movies and music.

• This setting is not available in either of the following cases:

– A pair of headphones is connected.
– Speakers B is on.
– Speakers A is off.
– Direct listening mode is selected.
– The  “Subwoofer” setting is set to “No” (

).

After changing the settings of the 

“

”

, 

“

”

 or 

“Audio Return Ch”

 

turn off the power on all connected pieces of equipment 
and then turn them on again. Refer to the user’s manuals 
for all connected pieces of equipment.

q/w and ENTER to select “Audio”, and then 

q/w/e/r to make the desired selection.