Sony STR-DN1010 Manuale Utente

D:\NORM'S JOB\SONY HA\SO0062\STR-DN1010\GB\GB04GET_STR-DN1010-CEL.fm

STR-DN1010

4-174-068-11(1)

After “MENU ON” appears on the 
display for a while, “GUI” appears and 
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not 
appear on the TV screen.

V/v repeatedly to select 

b.

The FM or AM menu list appears on the 
TV screen.

V/v repeatedly to select 

b.

V/v.

Press 

V to scan from low to high, press v 

to scan from high to low.
The receiver stops scanning whenever a 
station is received.

Tune in the station you want to listen to 
using Auto Tuning, Direct Tuning 

 

(page 54), or select the preset station you 
want (page 55).

Press TOOLS/OPTIONS.

Press 

V/v repeatedly to select “FM Mode”, 

then press 

 or 

b.

Press 

V/v repeatedly to select “MONO”, 

then press 

.

You can enter the frequency of a station 
directly by using the numeric buttons.

After “MENU ON” appears on the 
display for a while, “GUI” appears and 
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not 
appear on the TV screen.

V/v repeatedly to select 

b.

The FM or AM menu list appears on the 
TV screen.

V/v repeatedly to select 

b.

Example 1: FM 102.50 MHz
Select 1 

b 0 b 2 b 5 (b 0*)

Example 2: AM 1,350 kHz
Select 1 

b 3 b 5 b 0

* Press 0 for models of area code CEK, 

ECE, AU1, TW2 only.

Tip
If you have tuned in an AM station, adjust 
the direction of the AM loop antenna 
(aerial) for optimum reception.

“– – – .– – MHz” appears and then the screen 
returns to the current frequency.
Make sure you have entered the right 
frequency. If not, repeat step 4. If you still 
cannot tune in a station, the frequency is not 
used in your area.