Radio Shack XL-260 Manuale Utente

18

Operation

ˆ

The amplifier automatically turns on a few
seconds after you turn your vehicle’s ignition
switch to ACC or ON or turn on your auto
sound system, depending on how you wired
the system. The 

 indicator on the side

of the amplifier lights when the amplifier is
on.

Important: Your amplifier requires 31 amps
or more of power from your vehicle’s battery
during operation. To protect your battery
from discharging, do not operate the amplifi-
er unless your vehicle is running.

Note: Your amplifier temporarily shuts down
if it gets too hot, then restarts automatically
once it cools.

For the best performance, you must set

on the left and right sides

of the amplifier to adjust the level of the
audio signals that enter the amplifier. 

1. Use a screwdriver to turn 

 on the left and right sides of the

amplifier fully counterclockwise to 

.

2. Turn the auto sound system’s volume

control to about one-third of its full
range.

3. On the left and right sides of the ampli-

fier, adjust 

 to a com-

fortable listening level.

4. Turn up the auto sound system’s volume

control until the sound begins to distort.
Then immediately turn the volume down
to a point just before where the distor-
tion began.

Caution:  Never turn up the auto sound

system’s volume control more than
needed to adjust the audio level, or
more than two-thirds of its maximum vol-
ume.

5. On the left and right sides of the ampli-

fier, adjust 

 until the

sound is at the maximum level you want
the amplifier to produce.

6. Adjust the auto sound system’s volume

control to a comfortable listening level.

12-2017.fm  Page 18  Tuesday, May 9, 2000  10:02 AM