NuTone ISA-449WH Dépliant

1. Determine location for the speaker on outside of house –

near patio, on porch, or other desired location.

2. Locate speaker at a convenient operating height –

approximately 4

1

⁄

2

feet above ground.

1. Refer to Figure 1. Run cable from master station to

outdoor speaker location.

2. Run wiring through the hole in the mounting frame. Wrap

cable around plastic projection under wiring access hole.

1. Refer to Figure 1. The mounting frame may be mounted

directly to the exterior wall, or to a single-gang outlet box
mounted in the wall.

2. Before attaching the mounting frame to wall, apply a

continuous bead of caulk around the back edge of the
frame.

3. Secure mounting frame to wall with two (2) Nº 6 - 32 x 1

1

⁄

4

˝

mounting screws.

Refer to Figure 2. Remove plastic clip that holds the rubber
gasket to the printed circuit board.

Refer to Figure 3. As illustrated, connect wires from the
master unit to the six (6) screw terminals. Red wire to the
terminal marked red, red/white wire to the terminal marked
red/white, etc.

Refer to Figure 4. Fold rubber gasket over installed wiring.
Hold gasket tab to printed circuit board by folding tab over 
and sliding the removed plastic clip over tab and printed 
circuit board.