Samson SAMDR1248 Manuale Utente

18

The MDR1248 and MDR1688 has a dedicated input for 

playing back a stereo device such as a CD, Tape or Mini 

Disk.  Below is a description of how you can play back 

a CD, Tape or MD using the MDR1248 and MDR1688’s 2 

TRACK INPUT. 

 

1.    Turn the MAIN level control all the way down.

2.   Press the 2TK TO MIX button down.

3.    Adjust the MAIN LEVEL control in the master section 

to the "0" position.

4.    Start playback on the CD, Tape or MD player, and use 

the 2 TK LEVEL control to set the desired level.

You can record the audio from the MDR1248 and 

MDR1688’s mixer section including the MIC, LINE, 2T IN 

and AUX inputs to a Cassette deck, MD, DAT or any other 

type of recorder using the 2T OUT outputs.  Simply con-

nect the MDR1248 and MDR1688’s 2 TRACK  OUT to the 

input jacks of the recorder as shown in the diagram on 

the right and follow the steps below.

1.    Adjust the MAIN LEVEL  control  in the master sec-

tion to the "0" position.

2.    Set a clean signal using the recorder’s input level 

controls and meters. 

3.   Press RECORD.
4.    Play back using as described in the previous section 

"PLAYING BACK A CD USING 2T TO MIX". 

NOTE: To avoid feedback, be sure to keep the 2TK LEVEL 

control knob all the way down while recording with the 

2TK outputs.

If you prefer to use an external device for effects process-

ing, you can easily connect the unit using the MDR1248 

and MDR1688 AUX 2 bus.  Follow the simple steps below 

to interface your processor:

1.   Connect the AUX 2 OUTPUT to the input of the 

external effect processor.

2.   Connect the outputs of the effect processor to 

the AUX 2 RETURN located on the MDR1248 and 

MDR1688’s master section. 

3.   Set the MAIN LEVEL control to the "0" position.

4.   Raise the AUX 2 knobs for the channels to which you 

want the external effect to be applied.

5.    Set the input level of the external effect so that the 

sound is not distorted and so that the effect’s input 

meter does not indicate a clipped signal.

6.    Use the AUX RETURN 2 control to adjust the level of 

the effects processed by the external effects device.