JVC DX-T5 Manuale Utente
42
English
Handling cassette tapes
• If the tape is loose in its cassette, take up the slack by
inserting a pencil in one of the reels and rotate it.
– If the tape is loose, it may get stretched, cut, or caught in
– If the tape is loose, it may get stretched, cut, or caught in
the cassette.
• Be careful not to touch the tape surface.
• Avoid the following places to store the tape—in dusty
• Avoid the following places to store the tape—in dusty
places, in direct sunlight or heat, in moist areas, on a TV or
speaker, or near a magnet.
speaker, or near a magnet.
To keep the best recording and playback sound quality
• Use a cotton swab moistened with alcohol to clean the
heads, capstans, and pinch rollers.
• Use a head demagnetizer (available at electronics and
audio shops) to demagnetize the heads (when the System
turned off).
turned off).
Cleaning the System
• Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean
with a dry cloth.
diluted neutral detergent and wrung well, then wipe clean
with a dry cloth.
• Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it strong.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as
following:
– DO NOT wipe it with a hard cloth.
– DO NOT wipe it strong.
– DO NOT wipe it with thinner or benzine.
– DO NOT apply any volatile substance such as
insecticides to it.
– DO NOT allow any rubber or plastic to remain in contact
for a long time.
Troubleshooting
If you are having a problem with your System, check this list
for a possible solution before calling for service.
for a possible solution before calling for service.
General:
Adjustments or settings are suddenly canceled before
you finish.
]
you finish.
]
There is a time limit. Repeat procedure again.
Operations are disabled.
]
]
The built-in microprocessor may malfunction due to
external electrical interference.
external electrical interference.
Unplug the AC power
cord and then plug it back in.
Unable to operate the System from the remote control.
]
]
The path between the remote control and the remote
sensor on the System is blocked.
sensor on the System is blocked.
]
The batteries are exhausted.
No sound is heard.
]
]
Speaker connections are incorrect or loose.
]
Headphones are connected.
No picture appears on the screen.
]
]
The video cord connections are incorrect or loose.
No picture is displayed on the TV screen, the picture is
blurred, or the picture is divided into two parts.
]
blurred, or the picture is divided into two parts.
]
The System is connected to a TV which does not support
progressive video input.
progressive video input.
]
Incorrect color system is selected (see page 14).
The left and right edges of the picture are missing on the
screen.
]
screen.
]
Select “4:3 LB (MULTI)” for “MONITOR TYPE” (see
page 36).
page 36).
Radio Operations:
Hard to listen to broadcasts because of noise.
]
]
Antennas connections are incorrect or loose.
]
The AM loop antenna is too close to the System.
]
The FM antenna is not properly extended and positioned.
Disc Operations:
The disc does not play.
]
]
You have inserted a disc whose Region Code is not “3.”
(“REGION ERR” appears on the display.)
(“REGION ERR” appears on the display.)
]
The disc is placed upside down. Place the disc with the
label side up.
label side up.
ID3 Tag on an MP3 disc cannot be shown.
]
]
There are two types of ID3 Tag—Version 1 and Version 2.
This System can only show ID3 Tag Version 1.
This System can only show ID3 Tag Version 1.
To protect your recording
Cassettes have two small tabs on the back
to protect from unexpected erasure or re-
recording.
to protect from unexpected erasure or re-
recording.
To protect your recording,
remove these
tabs.
To re-record on a protected tape,
cover
the holes with adhesive tape.
EN_DX-T5[USUN].book Page 42 Tuesday, February 1, 2005 2:27 PM