Panasonic SC-PT 250 Manuale Utente

RQT8043

RQTX0055

■  Fitting speaker stands (not included)

Ensure the stands meet these conditions before 
purchasing them.
Note the diameter and length of the screws and the 
distance between screws as shown in the diagram.

• 

The stands must be able to support over 10 k

g.

• 

The stands must be stable even if the speakers are in a 
high position.

■  Preventing the speakers from falling

• You will need to obtain the appropriate screw eyes to 

match the walls or pillars to which they are going to be 
fastened.

• Consult a qualifi ed housing contractor concerning the 

appropriate procedure when attaching to a concrete 
wall or a surface that may not have strong enough 
support. Improper attachment may result in damage to 
the wall or speakers.

String (not included)
Thread from the wall to the
speaker and tie tightly.

Screw eye
(not included)

■  Attaching to a wall

You can attach all of the speakers (except subwoofer) to 
a wall.
• The wall or pillar on which the speakers are to be 

attached should be capable of supporting 10 k  per 
screw. Consult a qualifi ed building contractor when 
attaching the speakers to a wall. Improper attachment 
may result in damage to the wall and speakers.

• When mounting the front speakers to a wall, we 

recommend using a string (not included) to prevent it 
from falling.

Preparation for front speakers
1 Remove the speaker cable from the stand.

1

 Release the cable 

from the groove.

2

2 Connect the cable (

\ page 8).

1 Attach the cover plate to the front speaker

Screw
Tighten securely.

1

2

2 Drive a screw (not included) into the wall.

Ø7.5 to 9.5 mm

4.0 to 6.0 mm

Wall or pillar

Ø4.0 mm

3 Fit the speaker securely onto the screw(s) with the hole(s).

340 mm

200 mm

106 mm

In this position, the
speaker will likely
fall if moved to the
left or right.

Move the speaker
so that the screw is
in this position.

Example:

Reattaching the speaker cable to the stand
1  Remove the eight screws from the stand, and remove the 

speaker net.

2  Position the cable.

Approx. 15 cm

Press the speaker 
cable into the 
groove.

3  Attach the speaker net with the screws.

Metal screw holes
For attaching to 
speaker stands

Speaker 
stand
(not included)

5 mm, pitch 0.8 mm

Plate thickness plus 
7 mm to 10 mm

60 mm

Example: Center speaker

RQTX0055-B_Out_new14.indd   9

RQTX0055-B_Out_new14.indd   9

3/16/07   6:48:13 PM

3/16/07   6:48:13 PM