Cambridge Audio 540R V3 Manuale Utente

540R v3

azur

ENGLISH

All of the 540R v3’s rear panel video inputs (S-Video/Composite,

Component and HDMI) are freely assignable to the DVD, Video 1, Video

2, Tape/MD, CD/Aux and 6.1 Direct sources for maximum flexibility.

Select the ‘Input Assign’ menu. Highlight each Video input in turn and

select a source to assign it to:

Note: The 540R v3 prevents you from setting two sources to the same

video input, as this would cause problems, but doesn’t prevent you from

setting the same source to different video inputs.

The 540R v3 has two HMDI (High Definition Multi-Media Interface)

inputs and one HDMI output. HDMI is a fully digital audio/video system

that passes the picture and audio to the screen in digital format for best

possible picture quality. DVI (Digital Video Interface) is a subset of HDMI

that uses different connectors and only passes digital video to the

TV/Monitor (no audio). The 540R v3 is fully compatible with DVI in that

simple passive DVI-HDMI adaptors are available which allow the

conversion of the DVI connector to an HDMI format connector (and back

again if required) for routing via the 540R v3. The 540R v3 can switch

both types of signal.

The 540R v3 performs HDMI switching, not processing, it routes the

HDMI signals from the source equipment to the TV/Monitor without any

processing, so as far as the 540R v3 is concerned there is no setup

involved other than to assign the three inputs to a desired source. The

540R v3 does not receive audio or video over the HDMI, so for surround-

sound decoding etc, an audio connection must also be made from your

HDMI source to the 540R v3. As with other sources this can be analog

or digital audio. A digital audio SPDIF/Toslink connection is preferred

and will be required if it is desired to decode surround-ssound for the

HDMI sources.

Press the OSD button to exit the menu.

HDMI Pre-Emphasis

The HDMI interface is generally specified for transmission over cable

lengths up to 5m. For longer cable runs the 540R v3 is able to apply

some pre-emphasis to the HDMI signals to allow for cable losses in such

situations. For cable runs <5m HDMI Pre Emphasis should be ‘Off’. For

runs >5m HDMI Pre Emphasis should be ‘On’.

The maximum cable length possible depends on cable quality and to

some extent on the resolution of the video being transmitted (i.e. higher

bit rate signals are harder to transmit over long distances). HDMI cable

repeaters are available from acessory suppliers and may be required for

cable lengths >15m.

Select the ‘Output Setup’ menu, highlight ‘HDMI PRE’ and select either

‘Off’ or ‘On’:

Press the OSD button to exit the menu.

5. Assigning video sources

Output Setup Menu

Preamp Out : Normal
HDMI PRE : On

Return to Menu : [OSD]

Input Assign Menu

S/Comp1 : 6.1Direct
S/Comp2 : DVD
Component1 : DVD
Component2 : Video1
HDMI1 : DVD
HDMI2 : Video1

Return to Menu : [OSD]