Panasonic SCHC58 Manuale Utente

RQT9754

∫ Using the WPS Push Button 

Disconnect any devices connected to this unit.

Press and hold [– NETWORK SETUP] on the 
unit.

≥ Complete step 3 within 2 mins.

After “WPS” is indicated, press the WPS button 
on the wireless network router.

The unit’s settings are completed when 
“SUCCESS” is displayed and the Wi-Fi status 
indicator stops blinking and lights in blue.

Press [OK] on the remote control to exit the 

setting.

To use AirPlay, turn to page 11.

≥ To use the WPS PIN code, refer to the notes on page 10.

*1: WPS stands for “Wi-Fi Protected Setup

TM

”.

*2: “ _ ” stands for a digit that is unique to each set.
*3: Make sure that DHCP is enabled for the network 

setting on the iPhone.

With this method, you will access this unit’s 
wireless network settings from the Internet browser 
of your compatible device.
≥ The following explanations are based on an 

iPhone.

Press [SETUP] on the remote control 
repeatedly to select “NET SETUP” and then 
press [OK].

After “SETTING” is indicated, connect your 
iPhone to this unit’s wireless network called 
“00 Setup _ _ _ _ _ _”*

2, 3

.

Start “Safari” on your iPhone and type 
“http://192.168.1.12/” into the URL address 
field and display the page.

{.

This unit’s setup window is displayed.

(Continued on the next page)

Method 2

If your wireless network router supports WPS*

1

.

WPS Push Button 
Configuration (PBC) 
compatible wireless network 
router may have this mark.

“FAIL” may be displayed if the connection was not 
made within the set time limit. Try the setting 
again. If “FAIL” is still displayed, try “Method 3”.

Blinks purple

Blinks blue

Method 3

Setting the network connection from an Internet 
browser.

Blinks purple

Blinks purple

 _ _ _ _ _ _

SC-HC58~RQT9754.book  Page 9  Tuesday, December 18, 2012  4:40 PM