Jensen Tools JCD2006 Manuale Utente

JCD2006

4

2.

Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove and 
discard the trim ring.

3.

Remove the factory mounting 
brackets and hardware from 
the existing radio and attach 
them to the new radio. Select 
a position where the screw 
holes of the bracket and the 
screw holes of the main unit 
are aligned (are fitted). 
Tighten the screws at 2 
places on each side. Do not 
exceed M5 x 9 MM maximum 
screw size. Longer screws 
may damage components 
inside the chassis.

4.

Wire the new radio to the 
vehicle as outlined in the Universal Installation instructions.

5.

Mount the new radio assembly to the dashboard or center console using the reverse 
procedure of step 1.

When wiring is complete, reconnect the battery negative terminal.

Removing the Detachable Control Panel (DCP)
1.

Turn the power off.

2.

Press the 

 (release) button.

3.

Remove the DCP.

4.

For safekeeping, store the DCP in the plastic case 
provided.

Attaching the DCP
1.

Attach the panel at the left side first.

2.

Press the right side of the DCP onto the main unit until a 
“click” is heard.

CAUTION: 
•

DO NOT insert the DCP from the right side. Doing so may 
damage it.

•

The DCP can easily be damaged if dropped or subjected to 
a strong shock. When the release button is pressed and the 
DCP is unlocked, the vehicle's vibrations may cause it to 
fall. To prevent damage to the DCP, always store it in a protective case after detaching it.

•

The rear connector that connects the main unit and the DCP is an extremely important 
part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. 

•

If the DCP is dirty, remove debris with a soft, dry cloth only. You can use a cotton swab 
soaked in isopropyl alcohol to clean the socket on the back of the DCP.

Screws

Dashboard

Factory

Mounting

Bracket

Hook (Remove)