Kenwood KTC-SR903 Manuale Utente
— 6 —
English
You must have the Sirius ID number [ESN] for licensing with
Sirius Corp. Check the Sirius ID [ESN] of this unit as follows.
Sirius Corp. Check the Sirius ID [ESN] of this unit as follows.
1
Select the Sirius Satellite Radio Mode
Press the [SRC] button.
Select the "SIRIUS" display.
Press the [SRC] button.
Select the "SIRIUS" display.
2
Check the Sirius ID [ESN] of this unit
See the <Menu System> page of the instruction manual of
your control unit, and select the ESN menu item.
The Sirius ID [ESN] will be displayed.
See the <Menu System> page of the instruction manual of
your control unit, and select the ESN menu item.
The Sirius ID [ESN] will be displayed.
Serial & Sirius ID [ESN]
It is especially important to retain the unit serial number and the
electronic Sirius Identification number for service activation and
potential future service changes.
It is especially important to retain the unit serial number and the
electronic Sirius Identification number for service activation and
potential future service changes.
Sirius ID [ESN] display
Listening to the satellite radio.
Press the [SRC] button.
Select the "SIRIUS" display.
Select the "SIRIUS" display.
• You need to subscribe to SIRIUS to receive the service by Sirius
Satellite Radio. Consult SIRIUS if "CALL 888-539 SIRIUS TO
SUBSCRIBE"/"CALL 888 539-SIRI" appears.
SUBSCRIBE"/"CALL 888 539-SIRI" appears.
• It may take a little time to start receiving after you selected the
SIRIUS source.
• If the signal receiving fails, "Acquiring Signal"/"ACQUIRING
SIGNAL" appears.
Select Sirius Satellite Radio Mode
When you have the model-A control unit categorized by the
<Which is your control unit?> (page 5), follow the operation
instructions given below.
<Which is your control unit?> (page 5), follow the operation
instructions given below.
Press the [FM] button.
Each time the button is pressed the preset band switches
between the SR1, SR2, SR3 and SR4.
Each time the button is pressed the preset band switches
between the SR1, SR2, SR3 and SR4.
Selecting the Preset Band
Selecting the channel.
Press the [
4] or [¢] button.
Tuning
Putting the channel in the memory.
1
Select the preset band
Press the [FM] button.
Press the [FM] button.
2
Select the channel to put in the memory
Press the [
Press the [
4] or [¢] button.
3
Put the channel in the memory
Press the [1] — [6] button for at least 2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the memory on each [1]
— [6] button.
Press the [1] — [6] button for at least 2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the memory on each [1]
— [6] button.
• Only the channel number is stored. Category information is not
stored.
• This function can be used only when the "Channel"/"CHANNEL"
has been selected in <Switching Seek Mode> (page 7).
Channel Preset Memory
Operations from Model-A Control Unit
KTC-SR903(K)English 04.4.20 6:02 PM Page 6