Fusionbrands MS-RA200 Manuale Utente

INST

ALLA

TION

 The MS-RA200 is designed for vessels with a 12V DC Negative ground electrical system

 Appropriate mounting is very important to 

ensure correct operation. Select a location that allows 
both free/open airflow around rear of chassis, whilst 
minimizing exposure to moisture. Allow adequate 
room at the rear of the unit for the cable looms 
(approx 2”).

 

» Create mounting hole for product and drill Screw  
  Pilot Holes.  
  Refer to mounting template included with product  
  or download from www.fusionelectronics.com

 

» Fit mounting gasket

 

» Insert the unit into the mounting hole

 

» Use the supplied 4 x self tapping screws, to affix  
  the unit into position.

 

» Attach screw covers

Mounting Gasket

Screw Covers

Screw Pilot Hole

Mounting Hole

Rear support holes

INST

ALLA

TION

In some cases a rear support strap (not supplied) 
may be required. Please use the two holes indicated 
above, to attach the strap using two 8 gauge x 8mm 
self-tapping screws (not supplied).

 

» Ensure the marine vessels +12V lead is removed  
  from the battery before any equipment is  

 

 connected

 

» Investigate the marine vessels fuel tanks and  
  electrical wiring locations before you begin  

 

 installation

 

» Ensure all wiring is protected to avoid damage

When wiring the MS-RA200, ensure that the wires are 
away from sharp objects and that rubber grommets 
and insulated bungs are used when routing the 
wiring. Ensure that when connecting the wires to 
the speakers and audio system, the terminals and 
connections are protected from shorting to each other. 

 Ensure the Aerial cable is routed away from any 

power cables, and is the minimal length, as long cable 
runs will affect AM reception performance.

For optimum radio reception please ensure you use 
an independent am/fm marine antenna (ground 
independent).

Please refer to the following site for further info: 
www.pacificaerials.co.nz