ONKYO CR-515 CR-315 Manuale Utente

 

5

 

• If the remote controller doesn’t work reliably, try 

replacing the batteries.

• Don’t mix new and old batteries or different types of 

batteries.

• If you intend not to use the remote controller for a long 

time, remove the batteries to prevent damage from 
leakage or corrosion.

• Expired batteries should be removed as soon as possi-

ble to prevent damage from leakage or corrosion.

When you operate the remote controller, point it at the 
CD receiver’s remote control sensor, as shown below.

 

• The remote controller may not work reliably if the CD 

receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in 
mind when installing.

• If another remote controller of the same type is used in 

the same room, or the CD receiver is installed close to 
equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller because the buttons may be pressed inadvert-
ently, thereby draining the batteries.

• The remote controller may not work reliably if the CD 

receiver is installed in a rack behind colored glass 
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an obsta-

cle between it and the CD receiver’s remote control 
sensor.

 

Carefully follow the polarity diagram (positive 
(+) and negative (–) symbols) inside the battery 
compartment.

Appro

x. 5 m 

(16 ft.)

Remote control sensor

CD receiver