ONKYO CR-505DAB Manuale Utente

12

This chapter explains how to connect the supplied indoor 
FM antenna, AM loop antenna, and DAB antenna and how 
to connect commercially available outdoor FM and AM 
antennas.
The CD Receiver won’t pick up any radio signals without
any antenna connected, so you must connect an antenna to 
use the tuner.

The supplied indoor FM antenna is for indoor use only.

Once the CD Receiver is ready for use, you’ll need to 
tune into an FM radio station and adjust the position of 
the FM antenna to achieve the best possible reception.

Caution: Be careful that you don’t injure yourself 
when using thumbtacks.

If you cannot achieve good reception with the supplied 
indoor FM antenna, try using a commercially available out-
door FM antenna instead (see page 13).

The supplied indoor AM loop antenna is for indoor use only.

(The antenna’s wires are not polarity sensitive, so they 
can be connected in either push terminal.)
Make sure that the wires are attached securely and that 
the push terminals are gripping the bare wires, not the 
insulation.

Once the CD Receiver is ready for use, you’ll need to 
tune into an AM radio station and adjust the position of 
the AM antenna to achieve the best possible reception.
Keep the antenna as far away as possible from the CD 
Receiver, TV, speaker cables, and power cords.

If you cannot achieve good reception with the supplied 
indoor AM loop antenna, try using a commercially available 
outdoor AM antenna (see page 13).