ONKYO CR-505DAB Manuale Utente

24

Using the DAB for the first time:
When you first switch on the unit and select DAB, the Auto 
Tuning function scans the Band III frequencies.
After the scanning, the first scanned component will be 
selected and you will hear it through your speakers.
To listen to other stations, use one of the search modes 
shown below.
• Ensemble search mode: Selects the frequency (Ensem-

ble) (Page 24).

• Component search mode: Searches the components 

(Page 25).

• Sorted List search mode: Searches in the sorted order in 

the selected sort mode (Page 25).

• Preset search mode: Searches the preset components 

(Page 26).

You can use the Auto Tuning function manually:
You may want to re-tune at a later date if you move the CR-
505DAB or if you want to receive a newly introduced 
ensemble.
1. Press the [MENU] button.
2. Turn the [

] control to select “Auto Tuning” and 

push the [

] control.

3. The Auto Tuning starts and scans the Band III frequen-

cies. The number of scanned components are shown dur-
ing scanning.

Notes:
• You can also control this function using the [MODE], 

PRESET [

]/[

] and [ENTER] buttons on the 

remote controller.

• During BAND III scanning, the DAB only scans the 

audio services in the 174.928-239.200 MHz band range.

About secondary service:
If a secondary service exists, the “>>” symbol will light up 
in the “Ensemble No. & Freq.” Press the [ENTER] button to 
select the secondary service.
While the secondary service is selected, the “<<” symbol 
will light up on the display. Press the [ENTER] button to go 
back to the primary service.

You can select any frequency (ensemble) scanned by using 
the Auto Tuning function.