JAI TM/TMC-4200CL Manuale Utente

Mount the camera on a large heat sink (camera bracket) made out of heat-conductive material like 

aluminum. 

Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conductive 

material like plastic. 

Make sure the camera has enough open space around it to facilitate the free flow of air.

Please contact JAI at (800) 445-5444 or send an E-mail to imaging@pulnix.com if you have any 
questions. 

The TM-4200CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is 
Ground and pin #2 is +12V DC. The pin-out table is shown below. Serial communication camera 
control is accomplished by means of the Camera Link connector on the rear panel of the camera. 

1

GND

7

VD in

2

+12V DC

8

Strobe

3

GND (analog)

9

HD in

4

Video out

10

NC

5

GND (digital)

11

Reserved

6

VINIT in

12

NC