Bosch 1200 Manuale Utente

1200 Series IP Video Storage System

 Appendix | en

Bosch Sicherheitssysteme GmbH

Installation Manual

DOC | V1 | 2010.08

Note: This is a general block diagram and may not exactly represent the features on your 

motherboard. See the Motherboard Features pages for the actual specifications of each 

motherboard.

The X8SIL/X8SIL-F/X8SIL-V supports the Intel Xeon 3400 processor series. Built upon the 

functionality and the capability of the single-chip Intel 3400 chipset, the X8SIL/X8SIL-F/X8SIL-

V motherboard provides the performance and feature set required for single-processor-based 

systems with configuration options optimized for entry-level server platforms.The high-speed 

Direct Media Interface (DMI) featured in the Intel 3400/3420  chipset enables the X8SIL/

X8SIL-F/X8SIL-V motherboard to offer a high-speed Direct Media Interface (DMI) for chip-to-

chip true isochronous communication with the processor. This feature allows the X8SIL/

X8SIL-F/X8SIL-V to achieve up to 10 Gb/s of software-transparent data transfer on each 

direction, achieving better performance than comparable systems. The X8SIL/X8SIL-F/X8SIL-V 

also features a TCO timer (to enable the system to recover from a software/hardware lock), 

ECC Error Reporting, Function Disable and Intruder Detect.

–

Direct Media Interface (up 10 Gb/s transfer, Full Duplex)

–

Intel Matrix Storage Technology and Intel Rapid Storage Technology

–

Dual NAND Interface

–

Intel I/O Virtualization (VT-d) Support

–

Intel Trusted Execution Technology Support

–

PCI Express 2.0 Interface (up to 5.0 GT/s)

–

SATA Controller (up to 3G/s)

–

Advanced Host Controller Interface (AHCI)

This section describes the PC health monitoring features of the X8SIL/X8SIL-F/X8SIL-V. These 

features are supported by an onboard System Hardware Monitor chip.

BIOS provides a setting for you to determine how the system will respond when AC power is 

lost and then restored to the system. You can choose for the system to remain powered off (in 

which case you must hit the power switch to turn it back on) or for it to automatically return 

to a power on state. See the Power Lost Control setting in the BIOS chapter of this manual to 

change this setting. The default setting is Last State.

The onboard voltage monitor will scan the following voltages continuously: CPU core, +3.3V, 

+5V, +/-12V, +3.3V Stdby, +5V Stdby, VBAT, HT, Memory, Chipset. Once a voltage becomes 

unstable, it will give a warning or send an error message to the screen.  Users can adjust the 

voltage thresholds to define the sensitivity of the voltage monitor by using SD III.

PC health monitoring can check the RPM status of the cooling fans via Supero Doctor III.

This feature is available when the  user enables the CPU overheat warning feature in the BIOS. 

This allows the user to define an overheat temperature. When this temperature reaches this